I have a 2003 Dodge Sprinter. After it sits overnight, it will not start without using starting fluid.? - used dodge sprinter toronto
replaced by a new glow plug relay. Had a verification code will not display the code. Glow plug light turns off after the start of enigine. Once you start the engine is running perfectly. Can anyone help? THANKS
Tuesday, January 12, 2010
Used Dodge Sprinter Toronto I Have A 2003 Dodge Sprinter. After It Sits Overnight, It Will Not Start Without Using Starting Fluid.?
Subscribe to:
Post Comments (Atom)
7 comments:
Rick said, you do not use starting fluid in which damage to the piston up, try to control relays, just because the light goes out, does not mean that the glow plugs are heated, can badly or mass of fuel can escape back into it , which makes it difficult start.you, ll need to check the fuel pressure, with the glow plug and glow plug light relief under this Agreement may be bad and this may be what happens to him, not the law of the warming, but after the start in heat that would be a bad relay unit, good luck in this one.
I'm not saying that you can use the incorrect starting procedure, the structure of the statement.
The glow plug light has to go "before starting the engine, which ensures that the camera is hot enough to start burning to maintain. It may be necessary to preheat the bike two or three times, if under 32 degrees F. If To apply the correct procedure and starting the cycle of candles more than once without success, to start may be necessary to "connect" diesel night keep the engine warm for an easy start to the day.
We must keep our six diesel buses (two power strokes Ford, two from Cummins, Caterpillar 3208 and an internationally connected) is in the cold months for easy starts in the clock.
The light does not mean you can check the glow plugs are cut hot. And I would not fire ignition fluid it with everything that could make holes in the piston. There's even a warning label says not to remove the fluid out of service. Try WD40 start and if not, if your spark plugs
The light does not mean you can check the glow plugs are cut hot. And I would not fire ignition fluid it with everything that could make holes in the piston. There's even a warning label says not to remove the fluid out of service. Try WD40 start and if not, if your spark plugs
Check the connections, the gas line sounds like losing his first could also be a problem with the injectors or rings
Check the connections, the gas line sounds like losing his first could also be a problem with the injectors or rings
Fuel leaks, because leaks down.
Post a Comment